Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Beige on June 23, 2017, 11:35:40 AM
-
Hi,
I've just changed from TurboCNC to Mach3.
On TurboCNC jog mode, there is a "go to..." function,
that we can put a coordinate to go that position.
(For example, I choose X axis's "go to..." and write "30" then machine goes to X30.)
On Mach3, how can I get the same function?
Otherwise everything goes fine, I'm happy to change to Mach3!
Thank you in advance for your replies ;)!
-
Hi,
on the NFS website find
Mach3Mill_1.84.pdf (ftp://Mach3Mill_1.84.pdf)
Chapters 6 and 10 probably most immediately useful to you.
Craig
-
Thank you, I got it!