Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: eqrico2017 on June 18, 2017, 06:21:52 AM

Title: MACH STOPPED WORKING
Post by: eqrico2017 on June 18, 2017, 06:21:52 AM
I am using MACH3 under Windows 7 with Mach3-USB-3-Axis-CNC-Motion Control Card Breakout Board 2MHz. I made the setup and everything was
working perfectly. Suddenly the system stopped working, completely frozen. Motors, drivers, and card seem to be working fine. I noticed that MACH 3 main screen is frozen, not even able to move the axis in the screen
with the virtual jog, if I start a simulation with a toolpath uploaded, it does not run.
I tried to install again Mach3, even using another computer, Mach3 behavior is the same. Any suggestion will be highly appreciated.
Thank You
E.
Title: Re: MACH STOPPED WORKING
Post by: carter45 on June 19, 2017, 10:31:00 PM
Does the another computer running on Windows 7 as well?
Title: Re: MACH STOPPED WORKING
Post by: eqrico2017 on June 20, 2017, 03:25:21 AM
Yes, both computers have Windows 7.
Thanks,
E.
Title: Re: MACH STOPPED WORKING
Post by: bertus1945 on June 21, 2017, 07:58:47 AM
i have the same on XP machine