Machsupport Forum
Mach Discussion => Mach4 General Discussion => Topic started by: rrc1962 on May 26, 2017, 11:02:24 PM
-
Has anyone tried connecting to Mach3/4 via modbus using wifi? Technically, it should work just like wired connection. Just wondering if there is something about it that would required a wired connection.
-
Usng WiFi for a any quasi-real-time device is a bad idea, especially if the WiFi router is serving more than a couple of devices. The connection negotiation protocols can generate unpredictable and sometimes significant delays.
-
All of that considered though, is it possible? Or does Ethernet modbus require a wired connection?
-
Technically it should work if you get the IP addresses correct. You may have to do
this by configuring the router to "open a port" with a fixed address.