Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: wade16 on May 18, 2017, 04:31:40 PM
-
I installed Mach3 on my laptop with parallel adapter. It did the parallel port check O.K. When I load the program, the reset flashes and it will not stop when clicked on. It has a message saying External EStop Required. What do I need to do to reset the program?
-
Changing the Active state of the Estop in Ports & Pins / Input Signals should do it.
It should be pointed out that because of the various and many problems associated with laptops using a parallel port this method of operation is not supported by Artsoft. You should be using an external motion controller (such as the ESS, etc.) with your laptop.
Tweakie.
-
Thank you. That did it.