Machsupport Forum
Mach Discussion => Mach4 General Discussion => Topic started by: rrc1962 on May 18, 2017, 09:30:24 AM
-
In the pin setup I see Probe, Probe1, Probe2 and Probe3 on the M4 and ESS setup. I know G31 works with Probe. Would G31.1 be used with Probe1, G31.2 for Probe2, etc.?
Thanks
-
Simple answer
Your Correct ;-)
DazTheGas
-
Cool. I thought that was the case but thought I'd ask before chasing that rabbit through the hole.
-
Daz...
You wouldn't happen to know anything about Reverse Run in M4 would you?