Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: jordan21 on May 12, 2017, 09:21:56 PM
-
I have an ez-router cnc. I have been troubleshooting the last week to no avail. When I reference all home the z goes up and touches the limit switch but it won't back off of it. It just keeps crashing into it. So I replaced the limit switch and it does the same thing. I've replaced a ribbon cable, parallel cable, and limit switch. Nothing worked. I went into the button script editor and deleted the dobutton 24 to stop the z from homing. I then try to reference all home again with just the y and x axis. The y axis comes back and touches the limit switch and does the exact same thing. I am at a loss on want to look for. I am a week behind on schedule and am no closer in figuring this thing out. Any and all guidance would be appreciated. Thanks
-
Does anyone have any ideas?
-
If your using the parallel port, increase the Debounce in general Config. Try 3000, then 5000, then 10000.
-
Lower the speed % in homing and limits
Gary