Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: kimp on May 09, 2017, 02:07:52 AM
-
Hi all,
I have a newly built CNC machine and am trying to set up Reference home. In the diagnostics window I can activate the x, y, and z switches and they all light yellow in the diag window. I start the ref all home operation, the z axis starts moving up as it should, but when the home switch is pressed, it still keeps going up, it never stops until I press stop or EMO. HELP!!!
Thanks,
-
Have you reloaded Mach3? I had the same problem on my machine a couple of years ago. No matter what changes I made it would run past the limit switches and crash when homing. Reloaded Mach3 and the problem went away.
-
Hi,
double check that on Config/Ports an Pins/Input Signals that you have enabled X Home, Y Home etc...
Mach wont react to them unless they have been assigned.
Craig