Machsupport Forum
Tangent Corner => Tangent Corner => Topic started by: lemo on June 20, 2007, 10:35:06 AM
-
I wonder what tools I would need for my small taig mill to cut threads?
A v-cutter would probably do for my 4-th axis and the outer thread... but how can I cut a thread into a hole with the mill?
I try and cut threads more for an ornamental reason into 1-2 Inch wooden rods...
Thanks for some pointers!
Lemo
-
This is what i use.
http://www.harveytool.com/products/product_detail.php?product_id=71000&category_id=1&product_family=Thread+Milling+Cutters
-
Wow, thanks! That was quick 8).
Lemo
-
Thats exactly my wifes response.
-
ROFL
Made my day
Lemo ;D
-
Just get a tap of the right pitch and grind all the flutes off except one.
far cheaper and does the same job.
John S.