Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: chuck767 on April 29, 2017, 01:14:02 PM
-
I am putting a fourth axis on my table top, deep groove, milling machine
It was working but I wanted to fine-tune the movement of the motor and ended up changing something to the point where all the motor does now is vibrate when I try to move it.
I have tried everything I can think of but I cannot get the motor to rotate the way it did previously.
The motor is a pacific scientific. 5 V DC motor with 1.8° per step, 200 steps per revolution
Any ideas as to what I have inadvertently changed would be appreciated.
Thanks, Chuck