Machsupport Forum

Third party software and hardware support forums. => Galil => Topic started by: Andre Barclay on April 20, 2017, 10:31:56 PM

Title: Homeing Master/Slave with Mach4 and Galil DMC 2163
Post by: Andre Barclay on April 20, 2017, 10:31:56 PM

Hello,

I am finishing up a rather large router with the above setup and I am having an issue with homing the master/slave axis.  I only have a home/limit switch on the master axis and it looks as though as though Mach4 4 is trying to home both master and slave.  I have unchecked the "perform axis squaring", and I have the master/slave set up in Galil Suite and in Mach4.  Any ideas what I am doing wrong here?

Thanks for any help,
Andre