Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: BarryM on April 18, 2017, 12:59:42 PM

Title: Estop
Post by: BarryM on April 18, 2017, 12:59:42 PM

I'm new to Mach3 my issue is this when I turn my controller on and I'm in mach 3 screen the reset is flashing my steppers are locked when I reset the steppers disengage  it seems to work in reverse what did I miss Thanks for your help.

Title: Re: Estop
Post by: Tweakie.CNC on April 19, 2017, 01:57:24 AM

Try changing the Active state of the Enable pins that are used (Config. / Ports & Pins / Output Signals).

Tweakie.