Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: mbwittig on June 19, 2007, 02:59:21 PM
-
I've got the buttons installed on a panel on my machine and I've run wires to the parallel port input pins with the 470 ohm resistors like the docs say. I dont know how to make them push the buttons on the screen though. How do I link pins to pushing screen buttons like "run" "stop" and "zero x" ?
Thanks!
-Mike
-
Hey Mike,
You can set them up as triggers in ports and pins, inputs. Then go to config, system hotkeys and assign them an OEM code. I hope the pics help.
Brett
-
where do I get the codes from for each button on the display?
-
I think most of them are listed in the wiki. http://www.artsoftcontrols.com/MachCustomizeWiki/index.php?title=Main_Page Go down to section 9, OEM buttons.
Brett