Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: clachan on June 18, 2007, 08:57:25 PM
-
Can contrall X and Y from keyboard, but Z is not reacting for Page UP no Page Down keys. Z is fanctioning fine when I run a programm and also it runs well from MDI, any suggestions?
-
It sounds like you need to set your hotkeys for the z. In config, system hot keys. Click on the axis and direction button, (z- or z+) you will be prompted to hit a key. Default is page up and page down. If you don't use these, their may be conflicts with other keys.
Brett
-
Brett, thank you, works fine now
Vlad
-
Your welcome, :)