Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: truckeic on March 20, 2017, 09:00:44 AM
-
I had tried out MACH3 when I installed it and all motors turned with the arrow keys no issues. I just completed my X and Y axis yesterday and they seem to work as well. So then I tried to install the Joypad plugin and when I tried to turn the motors MACH3 looked like it went to run a program and now when I click an arrow key it moves one step and stops.. like its in jog mode but I am new to MACh so not sure where to look for this...
Also is there any tricks to getting the Joypad to work..
Thanks
-
Hi,
why bother with the joystick for the moment. Just use the arrow keys and the jog fly-out until you get familiar with it.
Craig
-
Hi,
why bother with the joystick for the moment. Just use the arrow keys and the jog fly-out until you get familiar with it.
Craig
I figured out my issue.. slmehow my jog type hot changed from continuous to step..
I got the joystick working as well..
Thanks