Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: kolias on March 19, 2017, 04:42:32 PM
-
On the attached snip, what is the purpose of the RPM line circled in red? At the bottom where the two zeros are I can see my spindle RPM but the red circled line always shows 0
-
Is that not the line that shows rpm from an encoder input?
I think my setup uses that line and it varies with load on the spindle etc.
-
Yes, it requires an input on the index input to provide the actual rpm to Mach3.
-
Thank you both