Machsupport Forum
Mach Discussion => Mach4 General Discussion => Topic started by: Maginsky on March 16, 2017, 10:05:47 AM
-
I was in the middle of machining a small part on my CNC milll using MACH 4. Assuming everything is still set...can the sequence be started from where it left off? Or should I start from the beginning and let it machine air till it catches up?
-
Hi Maginsky,
Check out page 42 of the Mach4 Operation Manual:- http://www.machsupport.com/wp-content/uploads/2014/05/Mach4%20Operation%20Manual.pdf
Just play around with the method outlined in the above (on a trial part, at slow feed and with your hand over the E-Stop button). Also use the FEED HOLD button and check the DISTANCE TO GO VALUES on each axis, untill you are comfortable with it.
Nick.