Machsupport Forum

Third party software and hardware support forums. => Third party software and hardware support forums. => Topic started by: Shawn1 on March 08, 2017, 09:15:40 PM

Title: USB Mkx IV controller
Post by: Shawn1 on March 08, 2017, 09:15:40 PM

Hello
Does anyone have better wiring diagram than the manual provides
I am just  learning started by a home built now wiring
I need to know where to wire the limit switches into
I put the home in the x y z home pins but am lost as where the limits go
Thank you in advance
Any and all help is greatly appreciated

Title: Re: USB Mkx IV controller
Post by: cosborne on March 11, 2017, 01:18:04 PM

I am working with a machine that has one of these controllers now.  I've set mine up to reference the home positions for each axis and then use soft limits.  From what I've seen so far it handles limits very nicely.  Alternatively you could use one of the inputs at the bottom of the controller. 

Title: Re: USB Mkx IV controller
Post by: cosborne on March 11, 2017, 01:20:42 PM

Here is a diagram that might help you a bit more.  It shows the inputs being used for x++, etc.

Title: Re: USB Mkx IV controller
Post by: Shawn1 on March 13, 2017, 09:08:13 PM

Thank you all
Great help
Almost done my build
Thanks you again
Shawn

Title: Re: USB Mkx IV controller
Post by: Alex He on May 25, 2017, 11:52:36 PM

Dear Sirs,

We have our new released Mach3 wireless MPG.


If anyone is interesting, you can contact me for details.

Regards

Alex He
ChengDu XinHeCheng Technology Co.,Ltd.
Add: No. 33,Wuqing South Road, Wuhou district.ChengDu City, Sichuan province, China(Mainland)
http://www.cdxhctech.com
Email: xhctech-alex@hotmail.com
Tel: +86-028-81701768  Fax: +86-028-81705368
Mob/What's App: +86-13568946750
Skype: alex86he