Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: koep on March 08, 2017, 12:17:19 PM
-
Hi All,
I'm milling round pockets spiraling out from center with 6 rounds.
With G2 everything is OK, but changing to G3 causes Mach to skip first 5 lines resulting in 1 round.
Has anyone seen similar? Is there a known cause?
Whats even more odd is that the same code works OK both ways on my second milling machine ???, otherwise identical setup, but runs win7 instead of XP.
Both have Mach3Version3.043.039 installed
All ideas welcome
Rgds,
Tapio
-
Upgrade to .062 and try again.
Cheers
Roger