Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: greek95243 on March 06, 2017, 05:12:46 PM

Title: z axis wont move up but will move down
Post by: greek95243 on March 06, 2017, 05:12:46 PM

this just happened don't know what happened

Title: Re: z axis wont move up but will move down
Post by: garyhlucas on March 06, 2017, 06:31:55 PM

If the motor isn't making bad noises then you likely lost the direction input to the drive.

Title: Re: z axis wont move up but will move down
Post by: Davek0974 on March 07, 2017, 02:18:16 AM

I was thinking that over on the other thread :)

But when that happens does it not move up for both up & down instructions?

Title: Re: z axis wont move up but will move down
Post by: terry1956 on March 07, 2017, 11:53:20 AM

Motor given up the fight lifting the head. Or you have the motor settings wrong.or a. Pulled wire to the motor