Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Fred_evans on March 02, 2017, 01:03:10 PM

Title: phils lathe screen setup 3rd axis
Post by: Fred_evans on March 02, 2017, 01:03:10 PM
My sincere thanks to Rich for his elp in setting up phils screen for my lathe.

It is a great step forward for me and i can see that i will like it

However now that i converted from the 1024.lset with only 2 axes- how do i get the 3rd axis to work-

I am just wondering if i need to go through the mill setup?? or are there just a few things
to do to get the 3rd axis to respond??

I need to learn these things without having my hand held arround every corner- so perhaps
you could just refer me to the appropriate sections in the appropriate manual ?

best regards

fred
Title: Re: phils lathe screen setup 3rd axis
Post by: RICH on March 02, 2017, 01:37:35 PM
Quote
how do i get the 3rd axis to work

You set up / configure the Y axis like you would configure any other axis.
First step is enable it. ;)

RICH