Machsupport Forum
Mach Discussion => Mach4 General Discussion => Topic started by: da40flyer on March 01, 2017, 03:29:55 PM
-
Looking at the measurements that can be taken under the "Touch" button, I see one for finding the center of a hole.
Is there one for finding the center of a solid rod (measuring via the outside diameter)?
-
unfortunately there doesn't yet appear to be a "boss" type function in the touch UI.
It is there under probing though, so hopefully they might add it to the touch UI too.
-
How does the Probing tab function differ from the Touch GUI?