Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Len-Tikular on February 23, 2017, 11:13:45 AM
-
Using Mach Turn and ESS
I just found out that automatic setup for homing and limit switches only applies to Parallel port boards. ??
Is there a way to do this using Smooth Stepper ??
What is the correct configuration of these switches for lathe operation ?
How can I set Z++, Z-- and Z home switches for my lathe ?
How can I set X++, X- and X home switches for my lathe ?
I will used two switches for my Z axis and wire them in series.