Machsupport Forum
Third party software and hardware support forums. => Third party software and hardware support forums. => Topic started by: Len-Tikular on February 22, 2017, 04:14:54 PM
-
Like most, I have a Boxford TCL160 lathe.
I'm using the original Inverter drive Mitsibushi Z024-UL
There is no Parameter unit fitted to the inverter so I cannot change any of the settings.
The Chuck is running flat out at 5Vdc and slows proportionally in keeping with the applied Voltage 0 - 5Vdc
Does anyone know what the actual speed of the chuck(Spindle) is at 5Vdc?
George
-
I don't know..........
You can buy a nice hand held electronic Chinese tach from Ebay for around $10. The one I bought works great!
RICH
-
Long time no hear from you Rich,
many thanks, that's exactly what I have done.
Thanks
George