Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: addicted2dunes on February 19, 2017, 02:31:49 AM
-
I'm sure you guys have answered this a million times but I came up empty on how to solve this issue. My X axis is moving the wrong direction (mirrored). I tried going in Config-Homing/Limits and checked the reverse box, but it didn't change anything, even after a restart. Am I missing something? Is there a way to reverse this? Or do I need to reverse the wiring or something? Thank you for your time.
-
Config. / Ports and Pins / Motor Outputs - Change the Dir Low Active state for the axis in question then Apply.
Tweakie.
-
Oh my god, thank you, that solved it, I was racking my brain on this and couldn't find the answer. Again, thank you so much.
-
This does not help me because my display reads negative from home in X and when I get it to read positive it will not bounce of the microswitch it tries to keep going When I get it to bounce off microswitch it reads negative from microswitch changing the left and right arrow as well