Machsupport Forum

Third party software and hardware support forums. => HiCON Motion Controller => Topic started by: Wallerawang on February 18, 2017, 04:12:51 AM

Title: Pokeys Pendant
Post by: Wallerawang on February 18, 2017, 04:12:51 AM

Hello Everyone
I have a Pokeys based pendant and I am wondering if there will be any issues running it at the same time as a HiCon controller in Mach 4?
Thanks
Steve

Title: Re: Pokeys Pendant
Post by: Vital System Support on February 18, 2017, 03:58:19 PM

As far as I know there are some installations using both plugins enabled.  so you should be fine. 

Title: Re: Pokeys Pendant
Post by: Wallerawang on February 18, 2017, 04:41:47 PM

Thank You ;D