Machsupport Forum
Mach Discussion => Mach4 General Discussion => Topic started by: Cbyrdtopper on February 14, 2017, 04:35:01 PM
-
I'm not sure what I've done. My MDI boxes won't work properly. I put code into them and it puts Mach in a RUN MDI State forever. It doesn't do any of the code, it just acts like its doing something and won't stop. Running G Code works fine, just nothing in the MDI. Any Ideas? I don't remember what to attach for the profile. Can someone let me know.
-
Have you done any customizing? If you have done any customizing you will have to think about what you did and undo it until its sorted. I would likely test with an unedited default profile, screen, modules, macros and all to see if that works right first.
-
That's the thing. The only thing that I've changed has been in the Mach Config and Modbus. Other profiles work just fine. Is there a way to restore previous versions? What little I've changed since yesterday won't matter to me, and it was working yesterday.
-
I found the "Restore Backup" Button on the Mach4 Loader. The backup from this morning works great. Not sure what I did. The only thing that I really recall doing was try and run the Gcode Execute and MDI Execute from a Macro.
Either way, if I figure out what it was I'll post it on here.
-
This is happened to me a few more times yesterday and today. The only time I know exactly what I changed was Activating Input0 in the Mach config. It did it twice when I did that. But the previous times this problem occurred I hadn't messed with Mach Input Configurations at all. So I'm still confused as to why I keep getting this error. I am still able to restore the previous backup and be just fine.