Machsupport Forum
Mach Discussion => Mach4 General Discussion => Topic started by: Firechief on February 08, 2017, 01:33:37 PM
-
What post processor do I pick when using VCarve pro 8.
firechief
-
Hi,
I don't know Vcarve but know that in most cases if Mach is not listed as a separate post then its common to
choose a Fanuc post. I do this with my CAM program and it produces one or two quirks that don't go down well
in Mach it is otherwise pretty good. Usually I have to edit 2-3 lines before loading and running in Mach.
Craig
-
What post processor do I pick when using VCarve pro 8.
firechief
Mach2/3 Arcs .... or Mach2/3 ATC Arcs .... work just fine.
Tweakie.
-
Thanks all for your help.