Machsupport Forum

Mach Discussion => Mach4 General Discussion => Topic started by: Firechief on February 08, 2017, 01:22:50 PM

Title: MACH4 EGDE FINDING
Post by: Firechief on February 08, 2017, 01:22:50 PM

I need some help with setting up mach4 with edge finding routine. How do you use a edge finder and set all the variables that go with it. Lot of help with Mach3 but not a lot with Mach4.
Please can some one make a video or manual that can explain the basic. with all the setting you need to do before you click cycle start.   ???

BIG THANKS

Title: Re: MACH4 EGDE FINDING
Post by: Chaoticone on February 08, 2017, 06:12:18 PM

If your using the touch button a video (and link to a manual) can be found here.  https://www.youtube.com/watch?v=VA49atQNzmg&t=3s

Title: Re: MACH4 EGDE FINDING
Post by: Firechief on February 10, 2017, 09:11:51 AM

Big Thanks, That should help me out.