Machsupport Forum

Third party software and hardware support forums. => HiCON Motion Controller => Topic started by: ChrisM on January 24, 2017, 09:39:23 AM

Title: Integra 7766 status output
Post by: ChrisM on January 24, 2017, 09:39:23 AM

Hi,

      I'm finalizing my control panel design and was wondering what things I can get from the controller and how to implement.  I'm looking for status things that would mimic the LED's on the board and maybe some other stuff I haven't thought of yet that would be helpful to run the machine. 

ARM
ERR
CPU
+24V
+5V

Etc.

Thanks for any help on this.

Chris...

Title: Re: Integra 7766 status output
Post by: Vital System Support on January 24, 2017, 10:27:21 PM

ARM LED can be mapped in Mach4 to any digital output using the ENABLE signal.

For Error and CPU LED there is configuration setting in the vsi Device Manager software.  Please consult the manual http://www.vitalsystem.com/portal/motion/VSI_Device_Manager_Manual.pdf

You can also configure key-lock switch input using this software.

thanks
Rufi

Title: Re: Integra 7766 status output
Post by: ChrisM on January 24, 2017, 11:38:19 PM

Thanks for the reply Rufi.  I'll take a look and see if I can implement a couple of these options.

Chris...