Machsupport Forum
Mach Discussion => FAQs => Topic started by: Kev on January 22, 2017, 12:55:37 PM
-
Hi everyone i'm fairly new to mach3 mill, the wizards are pretty cool but how do you machine for example a circular pocket and drill a bolthole pattern round it or a pocket inside a pocket in one go. Any one help me out here ?
-
My solution is to create a separate Gcode program for each different operation then run them consecutively after changing tools etc. (take care to use the same datum [X0,Y0] for each separate program).
Tweakie.
-
Cheers thanks for the reply, I see there is a mach3 mill wizard for about £60 might give that a trial too