Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: MarkC on June 11, 2007, 08:38:51 PM
-
Hi,
Is it possible to have the offsets work as a diameter instead of a radius?
I can't find anything except lathe as a whole as rad or dia, and this setting doesn't affect the offset register
Thanks
Mark
-
Anybody?
-
Hi, Mark
I think it's a work in progress Item, Not sure though.
Thanks, Chip
-
Thanks Chip
Hopefully it will happen
Mark
-
Not much of the lathe stuff ever seems to get worked on, that would be one of them. The lathe version of Mach3 switches between diameter and radius for quite a bit of stuff, you really have to watch it sometimes and try to learn it well.