Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: jkan101 on January 13, 2017, 06:40:32 PM
-
Just got my 4th axis for my taig mill.....when into ports and pins and enabled axis a and also checked off dirlowactive.....went into the motor tuning and setup and entered all the info there........and I get nothing when I try to jog the a axis .......any ideas or did I miss something?
Thanks
Joe
-
From the MPG screen make sure Jog mode is selected, does operation of the 4+ / 4- keys alter the 4th axis DRO's ?
Tweakie.