Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: krisverheyen on June 11, 2007, 08:43:11 AM
-
Hello,
I need to use both modbus and event driven serial control (port & pins config)
However if i switch on the serial function, the modbus is disabled, even tough there ports are set up different.
Is this normal? (then i have a problem) or has it never been detected. i'm using Mach 3 version 2.0.0.17
anyone?
Kris.
-
I think you are the first to do that :(..
I will ask Art about it this week
Thanks
Brian
-
Well eh,
at least i can say that i'm a pioneer ! ;D
a statue is perhaps exaggerated :D
enough foolishness.
I really hope this one is solvable.
I asked you a question about modbus over TCP last year, if ther's any progress in this area, that would also solve the problem.
Hope to here from you soon.
Regards,
Kris
-
Public Sub reply
While MsgBox ("Hello Brian, " & vbcrlf & _
"Did you get a chance to talk to Art about this problem yet?" ,vbYesNo) =vbNo
KeepOnWaiting ....
Wend
End Sub
::) :D :o ;D ::)
-
Hello Art or Brian,
Did you had a chance to discuss this problem yet?
I'm stuck at the moment.
Thank you
Kris
-
::)
-
Hello,
Any chance i can get an answer about my problem?
pleeeeeaaaase.
Kris
-
You can't do both on the same machine ;(
Sorry
-
OK,
I'll have to find a other solution.
Thanks
Kris
-
Looks like that limitation may have just been lifted :) Test the newest version to see if it works for you :)
Thanks
Brian
-
Hey thanks,
I'll give it a go when i get back on the job.
I'm on vacation right now.
Just movin from time to time to get the same color in front and back ;D
Greetz,
Kris.
-
I so need to do that!!!!!!
If you need me I will be sulking here at my desk ;(
-
Yeeeessssssss, it works (dance around, dance around) stiiirike!
Thanks very much!!!
You saved me hours of work!
Greets,
Kris.