Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: TM on January 12, 2017, 04:32:12 AM
-
Hello,
I have a very interesting problem, which I really don't know the reason for. Mach3 blocks in the middle/random part of the program execution. I have a PC with XP, and I have downloaded the last version of mach3.
Any suggestions, where should I look for the problem resolution.
Thank you!
-
Do you have a Mach3 license ?
Are you running Mach3 in Demo Mode ?
Is there any Status message at the bottom of the screen ?
Tweakie.
-
I have a license, but i am not sure what appeaers on the status bar. I will check and post.