Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Dougie on January 07, 2017, 09:07:48 AM
-
HELP! We are half through our biggest job (600 sheets of 18mm ply) and Mach 3 is starting to behave erratically.
There are 2 symptoms:
1) The 2 X drive stepper motors appear to go out of sync when returning to fixture zero causing the X carriage to jerk violently and derail.
2) Intermittently, starts cutting a file too early (ie short of X destination) on the X axis all the while making bad noise??
Can anyone help this operator. This happens about every 4th sheet?
Look forward to any suggestions. Thanks.
-
Loose wires, failing drive or motor? Carefully check both X axis motors and drives, and all wiring that they use.
-
Thanks Gerry
The one other main issue is when tracking to fixture home, that's when the X axis plays up. So will do the checks and report back.
Thanks for your speedy response.
-
With it being such a large job, my guess would be mechanical. Parts tend to wear out, although it could also be loose wires like Gerry said. But motors and mechanical wear would be where I start after checking those wires.
Highspeed