Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: jammyatter on January 05, 2017, 11:54:55 AM
-
I was wondering what settings in artcam people were using to engrave mdf and acrylic
Effectively. I'm sorry if this has been asked but I'm totally new to this. I've. Sorted a couple of
Jpegs to g code and they good in the simulation . But I'm not sure about some of the tool path
Settings regarding start depths etc Aand what bit is best . I was thinking 60degree v cut
And just an end mill to cut out
Cheers Jim