Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: leversole on December 16, 2016, 11:14:46 AM
-
When using Vcarve to generate code, I get these rounded pockets where it should be square. Anyone have any suggestions? I am using a standard Frued carbide tipped 60 deg VBit. I attached my tool settings...
-
Looks like it is trying to dogbone the corners, does it show on screen or not?
-
Screen, in VCarve and Mach3 show a straight line as you would expect...checked the bit also, it is 60Deg...