Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: paragon on December 11, 2016, 02:59:02 PM
-
Hi...after power outage ,one motor is not working...is therea reset for drivers..bob?....thanks
-
not usually, just full power-down and restart, check your fuses/mcb's etc.
-
Thanks, do the drivers usually have fuses?....what is mcb?...pardon my ignorance
-
No idea what system you have but there usually is a fuse or Magnetic Circuit Breaker (like a fuse but one that can be reset over and over, looks like a switch) in the supply somewhere. If there is none then it looks likely a drive has blown, the fact that other axes are working looks this way.
-
thanks for your help...i'll look for fuse or mcb tomorrow...