Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: MicroSD on December 04, 2016, 02:18:51 PM

Title: Slow multiaxis feed
Post by: MicroSD on December 04, 2016, 02:18:51 PM
Hi

The problem is that machine won't reach to g-code feeds. Every time when tool-path changes direction machine slows down. Is there any way to cancel such behavior or is this controller based issue?
Controller is some sort E-Cut controller, pic:  http://imgur.com/a/8P88H
Video of described behavior: https://youtu.be/0NyqkZ0JZpk

Haas has g187 smoothness parameter is there any chance that Mach 3 could have same kind setting?


Best Reagards!
MicroSD
Title: Re: Slow multiaxis feed
Post by: TOTALLYRC on December 04, 2016, 09:55:37 PM
Try putting a G64 at the beginning of your code. In the video the CV mode indicator is not green meaning that you are in exact stop mode.


Mike