Machsupport Forum

Third party software and hardware support forums. => SmoothStepper USB => Topic started by: thespindoctor on November 28, 2016, 06:59:29 PM

Title: charge pump function
Post by: thespindoctor on November 28, 2016, 06:59:29 PM

Using the ESS and C62 BOB with newly implemented charge pump.  The Gecko drives get power as soon as I relieve the Estop condition and there is no motor movement until I click enabled.  This is better but I thought I used to get no power to Geckos until I hit enable using old system with Mach3.   Would that be better?  Can that be done? 

Thanks
Keith