Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Chrisisdashiznt on November 21, 2016, 02:38:39 PM
-
everything went smoothly until I got into mach 3 I'm getting the error code of units:inches I'm going from qcad to sheet cam to mach 3 it is a tap file everything seems fine on my end just not sure where to go from here
-
Hi Chris,
How about posting the offending G-code?
Might make it a lot easier to help.
Mike
-
I'll load it as soon as I get home it's a super simple drawing I've done 3 so far with the same result with each one just trying to get something to cut lol