Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: ltdan on November 20, 2016, 12:08:20 PM
-
Hello all
So I think I have tried everything.....I have a servo motor and drive driving my spindle
.When I set the ports and pins for A-axis and enable it works great when I also set my spindle to the same port n pins A-axis continues to work but no spindle.
If I disable A-axis then the spindle works great. It is just when I enable the A-axis motor output the spindle doesnt work.
Any help I would be grateful
System is
Mach3
PMDX-126
Ethernet SS
Dyn-4 Drives