Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: brennon272 on November 17, 2016, 07:44:51 AM

Title: Help Me Retrofit My CNC Mill
Post by: brennon272 on November 17, 2016, 07:44:51 AM

Hey guys,

I just came into a BP Series II Interact II with a V2XT Control. Odd, I know. Anyway the control has had it and I am looking to retrofit the mill using the existing servo motors with Mach 4 (or 3). If anyone could direct me to a parts list or similar to do a complete retrofit I would be most grateful. Mostly everyone that I have seen bases their builds off of gecko drives but my motors are too big for them i believe. They are 26 IB/IN 4000 rpm max motors, 112 V and 65 A Maximums as well. I know this complicates things a bit but id rather not have to spend $$$$ on new servos when the ones i have are in good shape. Pictures to follow.

Title: Re: Help Me Retrofit My CNC Mill
Post by: TOTALLYRC on November 17, 2016, 05:25:32 PM

See if it is possible to use the existing drives as well. If they are analog input the DSPMC-ip runs them very well. There are other options as well, just look at the plugins page.