Machsupport Forum
Mach Discussion => FAQs => Topic started by: jake100 on November 11, 2016, 10:16:39 AM
-
first when i load a file the tool path it is displayed but when i start the cycle all that is shown is the cursor moving. and second when i go to reset the motosr still make noise have depower the board to make them go silent thanx
-
Well ive gotten no where on the general board so i'll try here ??? first when i load a file the tool path it is displayed but when i start the cycle all that is shown is the cursor moving. and second when i go to reset the motosr still make noise have depower the board to make them go silent thanx
-
Hi Jake,
I am sorry you did not get a prompt reply to your original question.
Can you attach your .xml file. It is located in your Mach3 folder and is called <your profile>.xml
Copy it and rename the copy to jake100.xml then use the Reply / Additional Options to attach the file.
What make and model controller are you using to drive your stepper motors ?
Tweakie.
-
Forgot to include I'm useing a chinese control and motors I think form Long motors
-
Forgot to include I'm useing a chinese control and motors I think form Long motors
If you are using Long's Motor parts then you should be able to identify the model of your controller from the pictures / description on their site http://www.longs-motor.com/
Please attach your .xml file
Tweakie.