Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: mismas on November 05, 2016, 12:49:55 PM
-
Hi Guys,
Hope somebody can help me with this. I searched the forum but didn't see any problem like mine...
I'm running demo mode of mach3. when i run it without the parallel driver installed mach3 works fine. g-code is loading and toolpath is generated perfectly. HOWEVER, as soon as i install the parallel driver and i load the same g-code the toolpath only shows a small section and when i scroll thru the g-code on program run page it seems to be "stuck" at random lines.
I assume this has nothing to do with it being demo version and more with a conflict? I have already tried another port address but this didnt help either....
anybody has an idea?. I ran out of ideas so any help is welcome!
cheers,
Mis.
-
No, it's a demo limitation, 500 lines of code is all it will display.
-
ah!!!...dumb me ;D....I just purchased a license.
thanks.