Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: DeanR181 on October 09, 2016, 06:49:10 PM
-
Hi all,
I have setup my Xbox 360 Controller on my CNC router as per the instruction in this video www.youtube.com/watch?v=-N0IANZcAFg and it works perfectly.
What i would like to do is program the micro jog which is also in this video but cannot figure out how to do it.
i have contacted the person in the video but have had no reply so hope someone else knows how to set it up and can let me know.
Thanks
Kind Regards
Dean
-
I have been looking for that too, I didnt fix it yet as I havent been out to my workshop yet.
try this link I found
www.machsupport.com/forum/index.php?action=dlattach;topic=12753.0;attach=42498
it explains a lot more than I know.
-
Thanks for the reply but the link you attached is the link to our messages. Any chance you can send the link again?
-
sorry, I thought it was taking me to the same page but suddenly a Word doc was downloaded. thanks for that. i will study it and see what i can make of it. If i work it out, I will let you know.
-
The thread it comes from is huge and it took me ages to find the good stuff, so I found a way to link to the word file,
sorry for the confusion.
-
no, thank you for sending it. i haven't got to look at it properly yet but hope to in the next few days. Work is priority (so i am told). ;D