Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: landermoto on October 06, 2016, 10:30:45 AM

Title: Mach3 - Jog Works but Step and MDI do not !!
Post by: landermoto on October 06, 2016, 10:30:45 AM
Mach3 Fresh install and setup on a Win7 - 32bit machine.
Mach3 ver. 3.043.066 DEMO

I am able to jog all 3 axes without issue. 

But get no movement when using STEP or MDI.

Oddly, when I switch between STEP and JOG, MACH3 requires a RESET.

I have a couple machines that use Mach3 and have never had this issue.

Digging around on the NET I found another person who posted the same issue, but no response was given.

Thank you in advance for your response.





Title: Re: Mach3 - Jog Works but Step and MDI do not !!
Post by: Hood on October 06, 2016, 05:07:56 PM
If you attach your xml then maybe the issue can be found.
Hood