Machsupport Forum
Third party software and hardware support forums. => Promote and discuss your product => Topic started by: Jeff_Birt on September 24, 2016, 05:15:59 PM
-
I have about 250 plastic tubes for 1/4" end mills. You could also use them for holding other small things. You can see pictures on this page: http://www.soigeneris.com/set_of_10_bit_tube__1_4-details.aspx . I want to sell the remaining 250+ tubes for one lump sum to get rid of them so $20 + shipping. To give you an idea of the volume they fill up a USPS large flat rate box which is $18.75 but it might be a few dollars cheaper to not go flat rate. If you are interested send me an email: birt_j@soigeneris.com with your shipping address so I can calculate the shipping cost.