Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: golash on September 10, 2016, 08:30:24 AM

Title: Best method to test for servo faults
Post by: golash on September 10, 2016, 08:30:24 AM
Hi all
Last year I did a complete rebuild of my control box for my wood router. I was wondering what`s the best way to
test for servo faults. My new system has a 70 volt power supply that runs with Geckos and 600 oz-in servo motors.
The machine seems more reliable and is faster. But I`d like to test it to see what the maximum ipm would be.
Not certain what the best type of g-code would be to check the machine.

Barry
Title: Re: Best method to test for servo faults
Post by: Hood on September 10, 2016, 11:55:17 AM
Jogging at full rapid is the way I test.
Hood