Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: aussieexpat on September 07, 2016, 02:39:28 PM

Title: I almost cant READ THE GCODE ON THE MACH 3 WINDOW!!!!!!!!!!!!!1
Post by: aussieexpat on September 07, 2016, 02:39:28 PM

PLEASE HELP I ALMOST CANT READ THE GCODE ON THE MACH 3 WINDOW, EVERY TIME I OPEN MACH 3 IT SEEMS TO GET SMALLER!! PLEASE, HOW ON EARTH CAN YOU ENLARGE THE GCODE THERE IS NOTHING ON THE FORUM. I CANT BELIEVE IT WHAT IS WRONG WITH THIS PROGRAME! IT IS SO FRUSTRATING!  THERE IS A PART TO ENLARGE THE FONTS BUT IT DOESN:T WORK!! PLEASE HELP A MACH 3 DUMMY!!!!!!!!!!!!!

Title: Re: I almost cant READ THE GCODE ON THE MACH 3 WINDOW!!!!!!!!!!!!!1
Post by: Hood on September 09, 2016, 03:37:34 PM

Only thing I can think of is the line count in the G Code window is set to a large number. Have you been editing the screenset?
Hood

Title: Re: I almost cant READ THE GCODE ON THE MACH 3 WINDOW!!!!!!!!!!!!!1
Post by: Stuart on September 09, 2016, 03:43:39 PM

I bet you have altered the font size in windoze in the display section

After all m3 uses the system font



Please don't shout I know I am deaf but take off the caps lock please